1) I am using 6.1.7 2) I am using the Xcelium version (side question has the incisive platform been renamed or is this an upgraded version but standalone?) 64bit. 3) I have checked the boxes in my output setups window in assembler and explorer to save and plot the signals I selected in the config view. Is there another form where I should check a box to save the signals? 4) below is the signal for the ben signals which should be a a pulse going from 0 to 5 with delay time of 100n, rise and fall time as 10n, pulse width 1s and period of 2s. The simulation is run for 500ns. I selected the tranOp folder in the psf directory and then selected instanced V49 which is the pulse wave source above. There is I, PWR, V signal but no ben net signal.
↧