So these are just warnings and the netlist files are created, the warnings relate to the device name being renamed to match the device name limit you have set. There are also warnings about signal models not being found but unless you are doing SI analysis on the pcb this shouldn't be an issue. The actual issue you have to resolve is that the PCB Footprint called 30PINCONNECTOR is not found in your library paths. Make sure that the 30PINCONNECTOR .dra and 30PINCONNECTOR .psm are available in the psmpath location. If you need to configure this look at: orcad.co.uk/.../Defining_padpath_psmpath.pdf
↧