Hey steve, I feel like i've done everything you suggested (minus repeating the uprev steps for bsm, ssm, fsm and osm, because I don't seem to have those options. Only have devpath, interfacepath, miscpath, modulepath, padpath, parampath, psmpath, steppath, techpath, topology_template_path), only to find the error remains unchanged. Still getting this message in netrev.lst "WARNING(SPMHNI-194): Symbol '30PINCONNECTOR' used by RefDes J12 for device '30 PIN CONNECTOR_0_30PINCONNECT' not found in PSMPATH or must be "dbdoctor"ed." Seems suspicious that this is only being flagged once (this component is found 4 times on the board) Also tried dbdoctor, and seemed to finish without issue, but still didn't solve the problem. Some info that might help. I'm a complete newb, and am finding the learning curve extremely difficult. I was given a .brd file that was made by a different company 3 years ago with the job of replacing obsolete components, with new components. I made the new shape, and footprint in pcb designer, saved it out, and used that as the new footprint for the old connector in the schematic(same number of pins). I very well may be doing this all completely backwards, but am too unfamiliar with the software to know that/if i'm making a mistake. I don't have access to the old library used to make the board, but I do have the .opj file. I feel like i'm so close! But I can't seem to get past this point.
↧