No problem at all. Ok so here is what was wrong. The footprint looked ok, pinning looked fine. The issue was with your symbols and what you were trying to achieve. Basically you have a footprint that contains two led's but in order to map your schematic symbols to that footprint you have to create a symbol that is of type "Hetrogeneous" This type of symbol contains two or more sections, typically A & B etc. What you were trying to do was use two individual diodes and package them to that footprint which wont work. I created a complete project for you. See attached in the next post. I renamed the diode to HSMF-LED for both schematic and the footprint. Just extract the files to a folder on your drive. I used c:\check here as a place to store them. Here are a few screen shots to show the main screens. Creating a new symbol that contains multiple symbols in one package. Symbol Sections: Part A Part B Schematic with notes: Netlist creation - Notice the paths ! "Makes things easier to find on your drive" See next post for project files..
↧