I am new to PCB Design. While designing PCB, I updated the 100 mil pitch 6 pin connector to 50 mil pitch 6 pin connector. I observe the Vcc_3.3V pin (1st pin highlighted in the image) antipad is all over the connector pins instead of only on at the first pin. The DGND pin (6th pin) antipad is also getting highlighted like Vcc_3.3V Pin. Even though there is no DRC error, I feel there is some kind of mistake near the connector. If anyone is familiar with this, kindly let me know. Pad Dimensions Drill - 26 mil
↧