Hello, I am simulating a mixed signal simulation with ADE / irun. Because of large amount of analig signals to be saved, the waveform (psf.trn) was too huge ~100G, if sst2 output format is used. Simivision is very hard to load up signals and easily crushed. So I decided to use psfxl and fast viewing extension in ADE -> outputs -> save all -> output options. In irun command line, I use -amsformat psfxl_all If I use gui mode, let simivion pop up during the simultion, the waveform borowing is fine. However, if I close down the simvision, and look at the psf directory, I see the following -rw-r--r--. 1 name rndenv 959 Aug 15 20:05 logFile -rw-r--r--. 1 name rndenv 3206256 Aug 15 20:05 psf.dsn -rw-r--r--. 1 name rndenv 222040 Aug 15 20:05 psf.trn -rw-r--r--. 1 name rndenv 9209100 Aug 15 20:04 tran.tran.tran -rw-r--r--. 1 name rndenv 22233737 Aug 15 19:06 tran.tran.tran.22.sig.tmp -rw-r--r--. 1 name rndenv 22229919 Aug 15 19:13 tran.tran.tran.23.sig.tmp -rw-r--r--. 1 name rndenv 22237871 Aug 15 20:04 tran.tran.tran.24.sig.tmp -rw-r--r--. 1 name rndenv 22237865 Aug 15 20:04 tran.tran.tran.25.sig.tmp -rw-r--r--. 1 name rndenv 23322023120 Aug 15 20:04 tran.tran.tran.dat -rw-r--r--. 1 namerndenv 22237865 Aug 15 20:04 tran.tran.tran.sig lrwxrwxrwx. 1 name rndenv 25 Aug 15 20:04 tran.tran.tran.sig.tmp -> tran.tran.tran.25.sig.tmp I tried " simvision psf.trn " in the command line, in simvision I only can see the design herirachy and signal names, but no any waves . from the data size, seems tran.tran.tran.dat is largest. I tried "simvision tran.tran.tran.dat" it says "File format not support" My question is , what is the correct way to open the wave with simivison in command line. Thanks a lot.
↧