I'm running Allegro 17.2 inside a Windows 7 VM on a MacOS host. The Windows 7 VM has the following specs: 256 MB Video Memory 8 GB RAM 56 GB SSD I've done testing with and without 3D Video Acceleration enabled. Even with the most basic FlexPCB design, when I start to bend, the program hangs and eventually crashes. For example, below I tried a small bend to start, but then the spinning wheel starts up and I'm stuck waiting until I kill the program: Has anyone seen similar behavior? Is there an easy fix to this, or is the bend feature in the 3D viewer too intensive to run inside a VM, and has to be a ran natively? Thanks, Jim
↧