Hi everyone, I have been trying to set up an optimization project in Design3D. It is for a centrifugal impeller with a blunt trailing edge (its a constant dmr blunt type). I had run an initial simulation in fine turbo and made a parametric model of the geometry in Autoblade. I used the geomturbo file from the Autogrid mesh as the target model for the Autoblade modelling. My problem lies when I try running the Screening operation in Design3D. I get the following error seen in image 1 which appears after STEP 4 Mesh quality failed in the Task manager tab Opening view computations info shows the following information: The quality report file was missing from the above directory. It was only in the directory where I saved the Autogrid mesh files. So, I then pasted the MKS.quality report file in the above directory ( \_trk\_flow\_mesh). The same error still appeared even after adding the quality file to the directory. I suspect maybe its the ''not being readable'' error now. I am not quite sure how to resolve this error and would appreciate any help. This error did not occur when I did the desgin3d tutorial 1
↧
