I Skill-coded two Pcells: A layout the schematic. The symbol is generated by the schematic-pcell. The LVS of the two pcells is clean. BUT: Whenever I try to place my layout-Pcell into another layout and try the LVS, the LVS-Check stops after a short period of time and I get the following Errors from the LVS-console: *Error* Could not determine the node name for terminal '"D"'. This may be caused by an error in the CDF specified on: component : ne5 named : /I0 in cellview : Test/schematic of library : work_jw "ERROR (OSSHNL-524): Netlisting failed because the function 'hnlNetNameOnTerm' was called with a non-existent terminal 'G' on the current instance 'I0' in the design 'work_jw/Test/schematic'. Provide a valid terminal name with this function and regenerate the netlist.\n\n" *Error* Could not determine the node name for terminal '"G"'. This may be caused by an error in the CDF specified on: component : ne5 named : /I0 in cellview : Test/schematic of library : work_jw "ERROR (OSSHNL-524): Netlisting failed because the function 'hnlNetNameOnTerm' was called with a non-existent terminal 'S' on the current instance 'I0' in the design 'work_jw/Test/schematic'. Provide a valid terminal name with this function and regenerate the netlist.\n\n" *Error* Could not determine the node name for terminal '"S"'. This may be caused by an error in the CDF specified on: component : ne5 named : /I0 in cellview : Test/schematic of library : work_jw "ERROR (OSSHNL-524): Netlisting failed because the function 'hnlNetNameOnTerm' was called with a non-existent terminal 'B' on the current instance 'I0' in the design 'work_jw/Test/schematic'. Provide a valid terminal name with this function and regenerate the netlist.\n\n" *Error* Could not determine the node name for terminal '"B"'. This may be caused by an error in the CDF specified on: component : ne5 named : /I0 in cellview : Test/schematic of library : work_jw End netlisting Feb 1 14:31:20 2023 ERROR (OSSHNL-514): Netlist generation failed because of the errors reported above. The netlist might not have been generated at all, or the generated netlist could be corrupt. Fix the reported errors and regenerate the netlist. I replaced the coded pcell schematic with a schematic I designed in the schematic editor, and ta da. The LVS is working now. So I strongly assume, that I forgot something in the skill-Code of the pcell - schematic. Do you have an idea, what I did wrong? Skill-Code is posted below.
↧