If I run a simulation in Explorer then want to plot results from clicking schematic nodes using Explorer -> Direct Plot it works great. But I'm not sure how to load a specific data set. There's a Results->Select option but it always only shows Explorer.0 1. If I run a simulation in Assembler then try to descend into Explorer to use Results->Direct Plot to view the results of one of the Assembler Runs, e.g. Interactive.XX then I don't see how to do that. 2. If I run a corner simulation and I only want to pick the results for one specific corner instead of plotting the entire family of curves when I use Results->Direct Plot I don't see how to do that either. Using Virtuoso IC23.1-64b.ISR8.40 Thank you!
↧