To define measurement statements and obtain simulation output results in a textual format using Allegro PSpice Simulator, you use the .MEAS (or .MEASURE ) command. This command allows you to define poki specific measurements on waveforms generated during simulations. To begin, you need to create a file with a .inc extension, which contains the measurement commands. This file is then included in your simulation setup. The general syntax for the .MEAS command is: .MEASURE {DC|AC|TRAN} , where {DC|AC|TRAN} specifies the type of analysis (DC, AC, or Transient), is the user-defined variable that stores the measurement result, defines the type of measurement (such as AVG , MIN , MAX , RMS ), and indicates the signal or waveform to be measured. For example, to measure the average voltage of a node out over a time interval from 1ms to 1.2ms in a transient analysis, the command would be .MEASURE TRAN Avg_Voltage AVG V(out) FROM=1ms TO=1.2ms . After running the simulation, the measurement results will be saved in a text file within the project folder, which you can review. I hope this helps
↧